ZY CLEANROOM - TRUSS & H-SECTION PURLINS
DRAWING-BASED ENQUIRY WORKSHEET

Company / contact / email:
Complete one schedule line per member mark. Attach the referenced drawings.
Keep cut lengths and design spans in separate drawing fields.
Mark unresolved items "To confirm". C/Z member dimensions do not specify a truss or H-section assembly.

1. Project location / building use / roof or wall framing zone
   Answer:

2. Drawing number / revision / units / design contact
   Answer:

3. Member mark / selected H-section, I-section or truss configuration
   Answer:

4. Section dimensions or truss geometry / referenced fabrication drawing
   Answer:

5. Member cut length / quantity / units / orientation
   Answer:

6. Steel material requirements / surface preparation / protective finish
   Answer:

7. End connections / plates / cleats / bolt and hole drawings
   Answer:

8. Bridging and restraint members / locations / associated part quantities
   Answer:

9. Supporting steelwork / bearing and connection interfaces
   Answer:

10. Roof or wall panel interfaces / openings / service coordination
   Answer:

11. Project-supplied design criteria / load information / approval responsibilities
   Answer:

12. Required fabrication and inspection documents / supply, packing, transport and erection scope
   Answer:

Send with drawings to info@zycleanroom.com.
This is an enquiry worksheet, not a structural calculation, approved substitution or certificate.
Offered specifications, quantities, design responsibility and delivery scope require confirmation.